| |
 |
Smartlab system
airflow control |
| |
The SmartLab Controller is a versatile, high-speed direct digital
controller specifically for airflow and temperature control in
laboratories and other critical environments. The SmartLab
Controller is a fully distributed microprocessor-based controller,
operating interdependently with other controllers in the lab.
Although each controller may share data with other controllers, each is
capable of maintaining its own control loops without intervention of other
networked or central controllers. |
| |
 |
Applications
-
For tracking total exhaust and supply air
-
Room
pressurization control
-
Room
temperature control
-
Laboratory
and critical environment airflow management
|
Technical Data Sheet
|
| |
|
|
| |
|
Smartlab system
graphical user interface |
| |
The SmartLab Configuration Software is a Windows-based graphical user
interface (GUI) which runs on a PC or laptop computer equipped with an
ARCnet adapter card. |
| |
|
Applications
-
control controller software
-
tune and troubleshoot lab fume hood controllers
-
can function as gateway to building automation system
-
protected by three-level password protection system
|
 |
| |
|
|
| |
|
Smartlab system
SLI-N2 converter |
| |
Designed solely for use with Tek-Air's SmartLab Control System, the SmartLab
Interface Converter provides seamless integration to Johnson Controls N2
network. The design of the SmartLab Interface Converter provides a
true communications protocol converter. There are two ports for
connecting the converter. The signals are isolated, and the
communications protocol is converted from one side to the other side in a
bi-directional fashion.
|
| |
|
Applications
|
Technical Data Sheet
|
| |
|
|
| |
|
lim-2000
smartlab system lab interface module |
| |
Designed solely for use with Tek-Air's SmartLab Control System, the LIM-2000
provides a communications port into a SmartLab network. The design of
the LIM-2000 incorporates a true communications signal repeater. There
are two ports to the repeater. The signal is isolated, and then
boosted in strength from one side to the other in a bi-directional fashion.
The main trunk connects all LIMs to one another and to the front end
computer. Due to the isolation provided by each LIM to its respective
lab, if there is a failure in the lab network, the main network remains
unaffected. Conversely, if there is a failure in the main network, the
lab remains unaffected. |
| |
|
Applications
-
The LIM2000 is provided in each lab in the SmartLab network
and provides a point to configure the lab controls. The
LIM2000 also acts as a repeater, allowing isolation of the
network trunk. In addition, the LIM2000 houses a temperature
sensor that can connect directly to the SmartLab Controller
input for measurement of lab temperature.
|
Technical Data Sheet
|
| |
|
|
